View Your Cart

Category:

Catalog Number:

JOHN F JENSEN'S SECURE SHOPPING CART

Pumps

JABSCO WATER PUPPY PUMP
See Larger Image
#JAB-WATP-01. JABSCO WATER PUPPY PUMP

JABSCO 12V WATER PUPPY IMPELLER PUMP
MODEL 18660-0121

Sells on internet for $125.00-199.00 plus shipping. Buy this one for 115.00

USES : Use for bilge pumping, livewell circulation, washdown and general pumping requirements.
If liquid being pumped contains significant amount of oil, use the pump model # 18660-0121 with the Nitrile impeller, which is an oil-resistant material.

Specifications:
6.3 GPM
Body Bronze
Impeller Neoprene
Seal Lip type
Voltage 12 VDC
8 Amp Draw
Fuse Size 15 amp
Motor Permanent magnet type, fully enclosed, stainless steel shaft.
Port Type 1/2" Internal Pipe Threads and 1" External Hose Barb
Adapter for 3/4" External Garden Hose Thread included
Size: 3" X 4 3/4" X 6 3/8"
Motor: Pmdc, Tenv 8.0 Amp
Nominal, 15 Amp Fuse
Ship Wt.: 4.5 Lbs
SELF-PRIMING: With a dry impeller, pump will produce a suction lift of about 3 to 4 feetand a lift of about 20 feet when primed.
Be sure suction lines are airtight or pump will not self-prime.
RUNNING DRY: Unit depends on liquid pumped for lubrication. Do not run dry for more than 30 seconds. Lack of liquid will damage the impeller.
PRESSURES: For operation, pressure should not exceed 8.7 psi (20 feet).
TEMPERATURES: Recommended for liquid temperatures of 45? to 180?F.

NOTICE:
The pump cannot run against a closed outlet such as encountered when using a garden hose type shut-off nozzle.

UPS ground insured shipping is $15.00..
WHEN ORDERING DO NOT INPUT ANY SHIPPING AS JENSEN WILL CALCULATE AND ENTER SHIPPING WHEN ORDER IS PACKAGED


1 in stock.
Price:Sale! $115.00
Qty:
Email to Friend
JABSCO MACERATOR PUMP
See Larger Image
#JAB-MAC-01. JABSCO MACERATOR PUMP

JABSCO 12V MACERATOR PUMP
MODEL 18590-1000

This is an new Jabsco warranty replacement Macerator Pump
Sells on internet for $120.00-170.00 plus shipping. Buy this one for 100.00

APPLICATIONS
The JABSCO 18590 series dc macerator pump unit is the ideal solution for emptying marine fish boxes and holding tanks.
It is self-priming to a five foot lift when impeller is wet, four foot when dry, and may be mounted in any convenient point in the discharge system.
The macerator section grinds waste down to a particle size of 1/8" (3mm) maximum so it can easily by pumped through a 1" (19mm) ID discharge hose.
The pump section is self priming,permitting the unit to be mounted above the tank in a convenient location. (For optimal efficiency, locatepump as close to the tank as possible.)
The macerator has an approximate flow rate of 12 GPM(45 LPM) and will empty a typical 30 gallon tank in less than 3 minutes.

FEATURES
Pump Body: Self-Priming Flexible Impeller with Stainless Steel Wearplate
Impeller: Jabsco Nitrile compound
Shaft: Stainless Steel Shaft
Shaft Seal: Lip Type
Ports:
Inlet - 1-1/2" (38mm)
Hose Barb and 1-1/2" N.P.T. (Male)
Outlet - 1" (19mm) Hose Barb
Motor: Permanent Magnet Type, Fully Enclosed, with Stainless Steel Shaft Includes Run-Dry Protection Device that shuts-off pump after 20 seconds of run-dry. Complies with USCG Regulation 183.410 and ISO 8846 MARINE for Ignition Protection.
Weight: 5 lb Approx

UPS ground insured shipping is $15.00..
WHEN ORDERING DO NOT INPUT ANY SHIPPING AS JENSEN WILL CALCULATE AND ENTER SHIPPING WHEN ORDER IS PACKAGED


1 in stock.
Price:Sale! $100.00
Qty:
Email to Friend
JABSCO WATER PUMP
See Larger Image
#JAB-WAT-01. JABSCO WATER PUMP

JABSCO 12V WATER PUMP
MODEL 31620-0092

This is an new Jabsco Water Pump
Sells on internet for $150.00-199.00 plus shipping. Buy this one for 125.00

FEATURES
Self-Priming to 10 ft
Runs Dry Without Damage
Smooth Flow
Four Piston, Diaphragm Pump
Powerful Motor with Thermal Overload Protection
Snap-in Ports
Pressure Switch with Boot
Meets USCG Regulation 183.410 and EN ISO 8846
MARINE (Ignition Protection)
Meets EN 50081-1 Electro-magnetic Compatibility

APPLICATIONS
The PAR-MAX Automatic Water System Pump is designed for self-contained boats and RV?s with multiple fixture water systems.
The system operates automatically.
When a fixture is opened, the pump instantly begins operation to provide a smooth constant flow from tank to faucet.
Closing the faucet automatically discontinues pump operation.

SPECIFICATIONS
Pump Body ? Glass Filled Polypropylene
Pump Design ? Multi-Chamber Diaphragm
4.3 GPM, 40 PSI
Suction Lift ? Self Priming to 10 ft.
Ports ? 1/2" Hose & 1/2" Threaded (QEST Type)
Motor ? Permanent Magnet

UPS ground insured shipping is $15.00..
WHEN ORDERING DO NOT INPUT ANY SHIPPING AS JENSEN WILL CALCULATE AND ENTER SHIPPING WHEN ORDER IS PACKAGED


1 in stock.
Price:Sale! $125.00
Qty:
Email to Friend